sawsall
dremel
4" grinder
rivets, scews,or welder
hole saw with PILOT
sharpies
tin snips
BFH
punch
beer
Attached image(s)
previous arrangement. huge hole in teh floor with 18 inch exhaust hole . teh rad was a huge brass monster. DE kicked it's ass. the air flow was wrong; no hi/low pressure delta.
Attached image(s)
gxcvxhn
Attached image(s)
teh fabrication in this large setup was very nice, well thought out and built just with wrong air flow characteristics
pre fit check
Attached image(s)
be sure to radius your corners in teh cut sheetmetal, we cont want any cracks later on. teh hole in teh floor was HUGE
Attached image(s)
dsgf
Attached image(s)
zgfsh
Looking good Sean! What kind of beer did you use for this project?
QUOTE |
What kind of beer did you use for this project? |
It should be higher on the list in importance.
Sean, you look like you are having way too much fun there pal.
Thats not Sean, thats his neighbor.
heres me
Attached image(s)
checking teh fit around teh latch before bending
Attached image(s)
does anyone else have photos of how they did their radiator install?
hjvngfd
Attached image(s)
looks good....custom radiator or OTS??
old rad w/ 18" fan
Attached image(s)
Fuidyne 4 row 2 pass. I think it was from Rod Simpson
very small. I am worried
there are alot of unknown components in this conversion...I know where I got the hoses
huge floor hole from previous radiator install
Attached image(s)
Sean,
Looking good, Got some low front views?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)