Hey guys/gals,
I purchased a set of rear tail light lens seals from 914Rubber (the soft silicone cords that are used to seal the lens to the housing, not the one between the body and housing).
Do these go in the groove in the lens or the groove in the housing?
Thanks,
Mike
Groove in the lens
Thanks Mark. That's where I thought they went but was not sure since they are not shown or listed on the PET and mine did not have any.
Thanks for responding, and yes the groove is where it's at.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)