Since not everyone wants to pound metal how about pounding down a few with dinner? The workshop should be done between 3 and 6 PM. Tony's shop is in Milpitas close to the Great Mall and McCarthy Ranch where there are lot's of places like Dave N Busters, Outback, Black Angus...
Open to suggestions!
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=31187&hl=workshop
I'll be there!
May bring my car as well! (depending on if its up for the haul....)
Andrew
You better be, your fee has been paid. I will bring the metal and f/g fenders for you to look at...
Sounds like a plan!!
BTW, Im buying lunch and dinn dinn!
I hope that it doesnt get in the way (Hopefully not... I highly doubt it..)... with a job opening up that I might get. Its construction and it will be starting around then or later. Its only for a month.. but it will be 10 hour days, 6 or 7 days a week at oogles of dollars per hour... Let me put it this way, I could buy a running six with what I could make in a month!!
I doubt I'd be able to lift after the workshop.
Actually I have to get back to visiting relatives that I'm abandoning by taking the workshop.
QUOTE (jonwatts @ May 25 2005, 08:44 PM) |
I doubt I'd be able to lift after the workshop. Actually I have to get back to visiting relatives that I'm abandoning by taking the workshop. |
There's still time to do the workshop and/or meet for
Don't regret missing this!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)