I reclocked my torsion bar adjuster caps recently. When I removed the caps there was, what I thought was dried grease around the base. I removed them and they basically desinigrated.
I have been looking at the parts diagrams and it looks like there is a gasket between the adjsuter cap and the suspension carrier.
Is this part needed? I would think that this is a fairly comon part but I cant seem to find it in the vendor catalogs.
Ya I need the same. Mine were like a brittle sponge, ha if that makes any sence.
If I were inclined to put something there I would think some felt cut to fit would make a nice grease retainer. That's really all it is, a grease retainer.
QUOTE |
Is this part needed? |
The last front suspension I did I couldn't find them either. They're foam pretty much. About a buck and a half each. Jason at Paragon was just about the only guy that even knew what I was talking about. Great guy, fantastic service.
http://www.paragon-products.com/
901.341.475.00
i bought 'em under that number from Stoddard.
PP has them as well. They're cheap.
Thanks
I may as well install them.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)