Printable Version of Topic

Posted by: freezing14 May 26 2005, 08:20 AM

that was on my 2.0 parts car,, the engine will be running after the guide job,, but should i put that muffler back with the 2.0,, and what is it from,, it just says KADRON made in bresil???

Posted by: Headrage May 26 2005, 09:44 AM

Got a pic???

Posted by: SirAndy May 26 2005, 10:20 AM

Posted by: tat2dphreak May 26 2005, 10:21 AM

didn't KADRON make carbs for beetles?

Posted by: freezing14 May 26 2005, 11:06 AM

something went funny when i uploaded the picture,, here it is


Attached image(s)

Posted by: Mueller May 26 2005, 11:11 AM

if "need" a muffler, that'll work, but I think you'd be better off throwing that thing away and put on a factory or a Bursch setup.....or go with a Traid if you have 2.0 heatexchangers (not sure if they make 1.7/1.8 mufflers)

Posted by: freezing14 May 26 2005, 11:18 AM

I do not have the heat exchanger, just some sort of headers, with a flange at the end

Posted by: Mueller May 26 2005, 11:21 AM

QUOTE (freezing14 @ May 26 2005, 10:18 AM)

I do not have the heat exchanger, just some sort of headers, with a flange at the end

at the end or ends??

if dual, you might have heat exchangers with the ducting removed....pretty common for rusty HE's

if the muffler you posted bolts up, you have modified heat exchangers....

a /4 header will have all 4 tubes converge into one tube