These are those pesky rubber bushings that go inside the top of the strut tower mount. Yes you can buy new metal mounts with the new rubber.....at $180 each!
I designed these to allow for install using a press, or with threaded rod, some washers and nuts. Getting the old one out is the hardest part. You can use a sharp knife to cut the upper lip and knock the rubber out the bottom. As the lip is what's holding it in. You can use a press and it will pop out.
Install is pretty easy. I designed it to act like a wedge-lock. Align the rubber in the metal part and use a bench vice (or press) to push the two sides together. I used a lower graphite content poly-graphite to allow these to push together under pressure. It creates a wedge lock that will hold the parts in place . You can see that the depth of engagement is correct on the top when the metal tube hits the ends of the bushing. It will be almost fully engaged but will require tightening about 1/8" more down during the install for the strut.
I think you will like these, especially for the price!
Also good to install while you do the A -arm rubber
Attached thumbnail(s)
In on these to
Can these be installed without having to do an alignment?
I will take a set too please
All in......heck just Main Line me
Add me! I got to kick this habit but you make good stuff!
is a "set" one side or for both right and left struts ???
Good question,
I typically (95% of the time) refer to a set as a complete car's worth. This is one of those times.
I know with my prices I've had people call to ask if it's enough for a car or if they need to order another.
I want to order these but don't see them on the website.
Am I missing something?
Thanks.
On the site now
https://www.shop.914rubber.com/Upper-Front-Strut-Tower-Rubber-Bushing-Set-GB-STRUT.htm?categoryId=-1
Codes sent to all this far
Thanks,
Mark
How does one know these need to be replaced ?
How does one know these need to be replaced ?
Code please
I'm in for a set.
I'm in, thanks!!
In for a set.
You got me again.
Im in.
PMs sent to all this far
I'm in for a set, PayPal sent. Mark
Send me one too, please.
Wife asked me today what I wanted for Christmas. I told her gift certs from 914Rubber. com.
She thought I was kidding.
Maybe we should add that option. We had never really done much as far as gift certificates but maybe we should ?
Ordered mine, thanks!
I'm in for a set. Thx
Jesse
Ok...I'm in again.
Add me to the list for front a-arm, rear arms and this strut top. Last did my suspension years ago when it was only creak/bang urithane available.
Great job Mikey.....Strut tower bushing went in great. Very nice product. Thanks, Mark
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)