Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ for those running 944 hubs/ 911spindles

Posted by: xsboost90 May 30 2005, 09:49 AM

so i have a 78 911 spindle setup, w/ some early 944 hubs and 911 rotors-which are the same as the 911 rotors actually. Now i had to space the calipers to fit the rotor since the hubs sit closer to the a-arms now than the stock ones. I noticed while lowering the car that the ball joint started to hit the rotor or get extremely close when it got too low. I took and "contoured" the outer point of the arm down for added clearance, but i also raised the car back up alot. Im thinking im gonna need some 911 hubs after all..anyone using 944 hubs with this problem. anyone have any 911 hubs??

Attached image(s)

Posted by: TimT May 30 2005, 09:50 AM

you need to space the whole hub out about 1/4"

VCI makes spacers

Posted by: 736conver May 30 2005, 09:52 AM

I dont have an answer to your question but man did you lift that front end up off the ground.

Posted by: xsboost90 May 30 2005, 10:58 AM

yeah she was up there. I would rather get some 911 hubs and make it right.

Attached image(s)

Posted by: goose2 May 30 2005, 11:19 AM

I may have some hubs for you...early 911. PM me.