I have just been very happy with the way my Ebay rockers are turning out. I bought these for $90 off Ebay. If I had seen them in person, I would not have paid more than $60 considering the amount of rust on the backside. Here is what they looked like when I got them. The surfaces were basically straight, with a few minor dings and creases.
Attached image(s)
This is a two in one shot: THe larger photo shows how I poured POR-15 for a nice coating on the backside. The upper left hand photo shows the results of DA sanding, followed by lots of wet sanding to a smooth finish. Then, I top-coated the bare metal areas with some self etching primer. One thing about whet sanding these - they rust fast! I had to dry them quick!
Attached image(s)
Now for the glory... here is a close-up with primer-sealer applied. I had to stop at this point, because of time constraints, but man do they look OEM. I have gone out to the garage several times just to admire them. Devilbiss guns are great!
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)