914.559.017/8.10 Left and right "cover plates"
We have been working on these for awhile. You can now get the German sail vinyl and the chrome strips for $74 69. I will sell just the chrome strips for $36 34.
Added in the protective film and actually was able to reduce the price some. Pretty sure most everyone can use a set of the metal ends.
I need the strips.
Interested
No we are workingon those, but they are still a way out. The tooling is a bit complicated.
These are the parts we have also added protective covers for the strips as these get boogered up pretty easily taking the roof off and on.
Attached thumbnail(s)
also including protective film for these as they are in a place that is easy to scratch up.
Easy to apply
Wet with soappy water
Apply film
Use plastic edge to press water out.
Use heat gun to wrap extra under
I superglue the edges and use a metal edge to press in.
Attached thumbnail(s)
Good idea. Always use protection.
Attached image(s)
I am in for on pair of these, and two couch covers!
Better pics of the ends (and better price) with the plastic covers $69 !!!!!
And you can combine with roof holders and another GB we are about to open.
Attached image(s)
Thats a good deal and worth it to me to store them until I am ready to reassemble..
I need those chrome strips as well!
I'm in for strips
Mark...I'll take a complete set...vinyl and the chrome strips...Thanks
Just bought a set. I need to replace mine as I think they are the originals but I'm a bit anxious about removing the various trim pieces.....
The hardest part of replacing the vinyl is to remove the roll bar pad. The screws tend to strip and if you are not careful you would have to drill out. Suboptimal at best. Use a #1 phillips for those.
The metal strips can be done without removing the roll bar pad.
Need a set of those strips please. The original ones looked crappy when I replace the vinyl with yours.
Buck
Are they aluminum or stainless ?
These are aluminum just like factory.
Add me to the list for vinyl, chrome strips and plastic covers! Thanks
PMs sent to all thus far - THX
Chrome strips please
By the way, when are you going to release a complete 914 as a kit?
Mark
I would love a set of the vinyl panels and the strips please. Let me know what I need to do to secure. I will have shipped to my son in SLC who will bring to the UK.
May need
PMs sent to all
Won't find them any cheaper anywhere else! Will run the GB til the end of the month
Mark...Great Deal. I will take a set.Thanks Bobco
in for strips
Actually, yes we are working on it and the retainer clips that are stupid expensive.
Bump GB ends 1/31
Please add me to the list for a set.
Add me
Thanks
As usual...
I'm in for the whole shebang
Please count me in!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)