Printable Version of Topic

Posted by: rad23racer Jan 22 2018, 04:19 PM

I used the search function but can't seem to find the info I am looking for.

I want to mate my engine and transmission tonight but can't seem to find info on lubing the throwout bearing and pivot bushing. Also, if anyone has torque specs for the bolts that hold the engine and trans together, I'd feel much better if they were torqued and not just "tight."

Thanks in advance. Yes, I have a Haynes manual but it really didn't provide the detail I would like. The Pelican article didn't seem to help either.

Rick

Posted by: worn Jan 22 2018, 04:58 PM

QUOTE(rad23racer @ Jan 22 2018, 02:19 PM)

Posted by: cuddyk Jan 22 2018, 08:00 PM

Haynes says 17 ft/lbs for the case nuts and 33 for the starter bolt.

I use a little lithium or bearing grease on the tube. The throwout bearing is pre lubed.

Posted by: 90quattrocoupe Jan 24 2018, 08:23 PM

I have found a product I like to use on pivot points. It is Loctite LB 8012. It is a high content(65%) Molybdenum Disulfide paste. The moly is suspended in a high temp grease(750 degrees). I use this in a lot of places and also use it as an assembly lube for CV joints. It seems to stick better than both copper slip and grease on pivot points.

Greg W.

http://na.henkel-adhesives.com/product-search-1554.htm?nodeid=8797877698561