While saving the good bits?
The front trunk firewall is perfect, longs and floors both perfect, need to keep the hell hole and rear clip intact as those are spoken for.
Rear window glass and targa top out and off respectively it would seem.
I cut the front floor then the rear floor leaving a floor section
I usually start cutting outside the longitudinal (not shown in this picture)
you can then take the front piece and rear piece to the scrapper
they are very manageable weight wise.
If you still need to make it smaller you can then cut the front and rear in half
the rear clip will stand up by itself for you to cut
if you are not going to save the longitudinal make sure to cut where the cardboard muffler piece is
Thank you Gene.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)