Started gutting for my rebuild and found a couple of areas needing new metal. I can fabricate if needed but if these are available somewhere I would prefer to just buy them, preferably new. In the photo the highlighted area that hold the seal for the front trunk and, also highlighted and circled in red the area that mounts the front hood release. I have a feeling this is the second hell hole on the car based on where it is welding is gonna be an issue.
The cowl was available as a factory part, and it may be possible to find an NO$ piece for that but doubtful. No one is making reproductions of that area at this time
Ive made Cary the channel marerial for the front trunk. Just needed some feed back, but as bent oieces these will be inexpensive.
Mark. I could use a piece of the channel if your making it.Let me know what length it comes in.Thanks Bobco
http://www.914world.com/bbs2/index.php?s=&showtopic=186566&view=findpost&p=1689299 you go.
A little rough but good for patching, & priced reasonably.
BPic he's waiting for me to get back to working on Taylor's car and use the pieces on Taylor's trunk channels.
Based on my schedule for the next 6-8 weeks I won't be back on Taylor's car till May.
Here's what Mark's had created.
It was created primarily for the channels around the headlight buckets.
If I were you I'd snag that piece Rich has offered up. If you don't take it I probably will take. Most cars have the issue your seeing in that left upper front trunk channel corner. The way they layered it it leaves a pocket under the old foam seal. As does the piece Rich offered.
The channel corner I repaired on Doug's car somewhere close to the end.
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=249327
The trunk pull pocket is a real tough repair. I think I did it on one of Mark's car. Can't find it at the moment. I'll keep looking.
That's a real tough place to work.
I stand corrected. Its on my own project car.
Starts about here.
http://www.914world.com/bbs2/index.php?s=&showtopic=187546&view=findpost&p=2300708
The answer to your basic question. Sunset Porsche shows both #1 and #2, NLA.
I don't want hold anyone up. I sure Mark can ship what he has made up already.
But they are straight pieces. One would need a shrinker stretcher to create the correct shape. IMO.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)