Had to remove the spring rods that assist the trunk lid opening. Haynes book says to get the tool, P304 to leverage them back in under the plastic rollers. Any other ideas to get these back where they belong? Don't ever,ever take these springs out!
You use a 12 " cresent wrench and cut a slot on one side wide enough to get the spring out later.Slip it over the end and leverage it under the spring hinge.Be careful. Wear leather gloves and safety glasses.Good Luck.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)