I got my car back from racerchris last week, Great welding on the engmankit and some other work. Now I am going though the engine bay etc and I have some questions.
What is the octagan pice and the sendor nearby (oil pressure?)
Attached image(s)
Now for a part under the rear trunk that looks like something should be bolted to it (same on opp side)
Attached image(s)
Last question (for now) does the clutch cable wheel need a cover?
Attached image(s)
1 Stock sway bar mount.
2 No cover, just keep it lubed
1.That is the bolt on the dizzy clamp.
2. Rear swaybar mounts.
3. no cover.
stock dizzy clamp
oil pressure idiot light sender
stock rear sway mounts
no cover needed
QUOTE (Aaron Cox @ Jun 5 2005, 02:24 PM) |
stock dizzy clamp oil pressure idiot light sender stock rear sway mounts no cover needed |
Yes Sir: cleaning now done Sir,
its white nylon and the center bearing should be clean with a dab of red grease on it. The nylon wheel should spin freely btw. A lite coat of grease on the cable to wheel is gud too.
i should see if i cant cut one out of aluminum when i get back to WKU.....i'll do a set or three of trunk rollers too.....
an aluminum clutch pully really wouldn't be much value- it doesn't really ever wear. Now, a cover.... Actually that seems like it might be really good.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)