I put a lot of time setting up the heating system, only to find out that I should block off the right heat exchanger. I hate to do that so I am in need of a splitter for the hose used on 75-76 models. Any one have one?
The blower
Attached image(s)
call the usual parts houses, EASY, HPH, Parts Heaven etc ...
also, you could "upgrade" to the VW-bus blower that has 2 outlets ....
Andy
Sir Andy, I have a 2 outlet blower from a 914, just would like to use the mount in the car. Found AA has it but $$. Looking for one someone may have laying around.
Pelican has the tubes, and the splitters.
M
QUOTE (Garland @ Jun 5 2005, 05:04 PM) |
Found AA has it but $$. |
I will try Pelican in the morning. There listing has the tubes only, yet the picture shows the spliter.
QUOTE (redshift @ Jun 5 2005, 07:04 PM) |
Pelican has the tubes, and the splitters. M |
QUOTE (Garland @ Jun 8 2005, 09:57 PM) |
Worked with 3 Pelican part guys over 4 days |
I here you and I will call them all this time, and let you know.
PP sells new parts and EASY, HPH, Parthaven sell used parts which I haven't heard of the splitter being available new.
I'll be putting my heating system in soon, I have the spliter to go on the fan, here is my question, if you route the fan output hoses to both sides of the engine sheet metal (through the tubes), where do you get the fresh air for the fan input? if any?
QUOTE (kenpolives @ Jun 9 2005, 09:42 AM) |
where do you get the fresh air for the fan input? if any? |
Yep, Ernie is correct.
I wish there was some way to make the booster fan hoses look decent in the engine compartment.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)