I have two pair of hubs for my 914-6, one that is original and another pair I got at a later time. I'm not really sure which is which or what the difference between them are. Anyone know what the difference is? Here are some pictures and part numbers.
http://oregonstate.edu/~wolcottr/Porsche/Hub/
911.341.605.4R (appear to be cast)
901.341.605.3R (lighter weight and smooth)
Thanks,
Bob
QUOTE (Bob Wolcott @ Jun 7 2005, 12:29 AM) |
911.341.605.4R (appear to be cast) 901.341.605.3R (lighter weight and smooth) |
not sure but do you want to sell the set you dont use? I need some hubs bad!
I do plan to sell one pair of these but I am not sure which. I will be running an RS motor in this car with wide tires etc... and I really need the strength, if there is a difference.
Bob
Use whatever seems to be in better condition. If you are going to race it consider going with longer studs and open headed nuts...same with the rear.
haven't checked the numbers, but those may be early vs late hubs
(the 901's being early and the 911's being late)
Have you measured them out side by side? I haven't seen the machining marks on any of my hubs. It looks as though someone may have milled the mounting surface of the hub in the 005 picture...
I don't think there's a difference in strength or any need to care. I've never heard of "any" 911 hub failing. If they measure out the same, I'd simply use the 901 hubs that came with the car and sell the others to Dan.
QUOTE (Bob Wolcott @ Jun 7 2005, 10:13 AM) |
...I really need the strength... |
QUOTE (ArtechnikA @ Jun 7 2005, 11:03 AM) | ||
if you *really* need the strength, don't mess around with any of the factory stuff and get the billet hubs from SmartRacing. |
QUOTE (Mueller @ Jun 7 2005, 02:11 PM) |
the SmartRacing hubs are the 930 style front hubs (built in 1" spacer)..unless they have another one that I didn't see in the catalog.... |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)