I installed a crane XR700 in my dizzy and the rotor seems to be sit a little high now. When you look into the bottom of the rotor you will see a molded key thang that sets into a notch in the distributor shaft. This prevents the rotor from spinning once it is pushed onto the shaft.
When I push the rotor onto the shaft it hits the black optical disc. The molded thang in the rotor really doesn't set into the notch very deeply. If I twist the rotor by hand it will pop out of the notch and spin on the shaft.
Can anyone measure the amount of shaft that extends above the optical disc for me?
Cheers
QUOTE (Kerrys914 @ Jun 7 2005, 09:46 AM) |
I installed a crane XR700 in my dizzy and the rotor seems to be sit a little high now. Can anyone measure the amount of shaft that extends above the optical disc for me? |
i have a picture somewhere towards the end of my progress thread. The way i set mine was lined the square points cam up w/ the square inner clips on the wheel..slid it down to there and put the rotor on all the way. Slid the wheel up to the rotor and thats where it stays. There is no force put on the wheel so as long as its snug and spins straight, your cool!
QUOTE (xsboost90 @ Jun 10 2005, 07:57 AM) |
The way i set mine was lined the square points cam up w/ the square inner clips on the wheel |
okay - the close-focus capabilities of my digital camera are really frustrating me. the film stuff is better but it'll be a bit before i can get that processed and scanned...
there is 17mm from the top of the rotor drive shaft to the top of the plastic shutter wheel.
Attached image(s)
Thanks
The measurement will be fine. Once i get home I'll check it out.
I would feel better if I could get another 2mm or so of depth in the rotor. IIRC, the rotor is sitting tight on the black optical disk.
Thanks guys.
In your photo, what is above the flat part of the disk (the piece that has the slots in it)?
It looks like there is somthing in the shaft above the thin disk.
QUOTE (Kerrys914 @ Jun 10 2005, 09:09 AM) |
In your photo, what is above the flat part of the disk (the piece that has the slots in it)? It looks like there is somthing in the shaft above the thin disk. |
I have the shutter wheel but I installed mine with the "HAT" down. I don't recall if it had the hex molded into it or not?
It looks like in your photo the "hat" is up or ? is on the shaft just above the shutter wheel
Cheers
mine came w/ a pile of shutters,and a diagram. I can check it out if you need one tonite.
QUOTE (Kerrys914 @ Jun 10 2005, 09:49 AM) |
It looks like in your photo the "hat" is up |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)