I am looking for the thing that bolts onto the side of the tranny and holds the accelerator cable. #11 in the pic. Anyone have one, or know where to find one?
Attached image(s)
Check with Dan Root, I think he makes the whole little doodad setup for those.
I do, have a couple left from the last run I did too. They use the stock 914-4 cable, bolt right onto the trans. Comes with the rod. If you have CIS, you just need to make sure your engine has the linkage on it. Same with carbs and someone who bought one even told me it snaped right onto the ball pin on his DME 3.2 914-6. So should work from carbs to DME's.
I have the bell crank, and a /6 accel cable, I just need the metal piece in the pic. Do you have that sepparate, Dan? $?
If Dan doesn't have one, they are still avail from Porsche, and I could get one for you..they're pretty cheap, too
Eric
Thanks for the offer, Eric. Could you tell me what the cost is?
they list at $14.92...club price of $13.43 plus shipping
Eric
QUOTE (Dr Evil @ Jun 8 2005, 12:03 AM) |
Anyone know where to find one? |
Done. I don't wanna F with it anymore, just get it done.
I'll PM you.
Thanks again!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)