Does anyone no how to install this clip on the rear brake caliper piston dust but?
Thanks Nino
Attached thumbnail(s)
There should be a lip at the base of the rubber boot, and there is a ridge inside the caliper bore. After placing the ring around the base of the boot, than compress the ring, overlapping the edges, push with a blunt tool, into the bore .
Fit it properly or the you can rip the piston boot....take care.
PMB has a very detailed video at their website.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)