Hello All,
I was hoping if someone has been there and can share where I can find the spark plug wire ends that would fit this coil pack. An universal plug set would be ideal. I am going to use this for my Microsquirt conversion.
Any leads or links would be appreciated.
Thank you
It is an end
The wires hook up to the connector with the 4321 on it in the pic posted.
You would need the matching connector with a pigtail to connect to MS. Cut from a scrap car harness.
You will also need to figure out a way to bolt them to the engine tin and a seal. The 1/3 coils might stick out a fair bit on a T4.
Thanks, I got the connector end figured out, tracked down the connector kit to crimp my wires into.
The coil pack spark plug tower is different than the distributor cap on stock T4, looks like a sharp point inside that gets attached.
No clue what you're talking about.
I need a set of spark plug wires that fit this end of the coil pack.
It is not the same as our T4.
You need connectors something like these, they are some old Audi coil/plug wire connectors.
Jim
Beru 0 300 513 119
1k ohm
I need a custom length set so they can reach the spark plugs.
Ordered w sets of these and used the 2 longest from each.
https://www.amazon.com/gp/product/B016D95420/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
I get it now, I was thinking COP.
Magnacore will build you any set, length, ends you want.
My T4 conversion bug has GM coils, I bought a V8 set of Accel wires and got 2 sets.
Here's the set that came with Matt's MicroSquirt.
http://thedubshop.com/universal-air-cooled-spark-plug-wires/
Goes into the same wasted coil pack as The Dub Shop calls it.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)