My targa top latchs fell apart when I took the roll bar pad off and I am hoping someone can post a pic of them together. When I was at AA George sent me home with a couple of Rear Window Caps for the job but I didn’t see them during the disassembly and can’t figure out where they go. It’s a 73. I have the glass back in already so I hope if they are needed I can still install them. Anyone know?
Two little rectangle rubber strips/blocks?
Under the bottom of the window pane to hold it up off the sill bottom.
Again....
I’m thinking like this and I’m missing some Cclips and that’s why they came apart.
Attached thumbnail(s)
I found a picture showing how the latch goes together and I am missing the Cclip or wire retainer that holds them together. I guess it works without them since they weren’t there when I took it apart. I would like to replace them though. Any one know what will work and where to get them?
Still no idea what these plastic clips are for??
Not a roof part. Is there a part# on the bag?
It’s number 5 in the AA catalog on page 101 and here’s a pic of the bag. Also pn 914 552 174 10. I was trying to figure it out today so I could reassemble but I may need to call AA tomorrow
Attached thumbnail(s)
The plastic clip is the part that fits in the door . It finishes off the rubber / window goes through it .
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)