Posted by: aharder May 26 2018, 02:36 PM
As you can see my mounting hole has been screwed
The right side is also screwed but not as bad.
Looking for some dimensions of the hole placement so I can start to repair.
Thanks
Posted by: majkos1 May 27 2018, 09:36 AM
will this help?
I measured the metal area,
2" on the Left
I 1/2 on the bottom.
Posted by: majkos1 May 29 2018, 09:41 AM
I found this on one of many 914's I chopped up over the years.
Posted by: majkos1 May 29 2018, 09:45 AM
Anybody wants it?
It's on my Wall of Shame
Posted by: mepstein May 29 2018, 10:16 AM
QUOTE(majkos1 @ May 29 2018, 11:45 AM)
Anybody wants it?
It's on my Wall of Shame
I have one almost as bad from a parts car. Stick welder and por15.
Posted by: majkos1 May 29 2018, 01:14 PM
QUOTE(mepstein @ May 29 2018, 10:16 AM)
QUOTE(majkos1 @ May 29 2018, 11:45 AM)
Anybody wants it?
It's on my Wall of Shame
I have one almost as bad from a parts car. Stick welder and por15.
Same. stick welding but, Foam in a can!?
Then sculptured,
Posted by: mepstein May 29 2018, 01:25 PM
QUOTE(majkos1 @ May 29 2018, 03:14 PM)
QUOTE(mepstein @ May 29 2018, 10:16 AM)
QUOTE(majkos1 @ May 29 2018, 11:45 AM)
Anybody wants it?
It's on my Wall of Shame
I have one almost as bad from a parts car. Stick welder and por15.
Same. stick welding but, Foam in a can!?
Then sculptured,
Foam in a can and pieces of scrap copper made up the right engine shelf in another one of my cars.
Attached image(s)