Posted by: Tdskip Jun 16 2018, 05:45 PM
Went to pull the clutch off the new to me low mile 2 L engine and the pressure plate bolts don't allow a socket to fit securely on them.
Is this normal, or is my "fun" with this engine about to start in earnest?
Posted by: Tdskip Jun 16 2018, 06:22 PM
QUOTE(76-914 @ Jun 16 2018, 06:55 PM)
use a crows foot
So not necessarily indicative of anything wrong? All of the tutorials I found via searching just used a socket without issue.
Thanks!
Posted by: Tdskip Jun 16 2018, 06:27 PM
One I have is too thick...
Attached thumbnail(s)
Posted by: mlindner Jun 16 2018, 06:33 PM
Will a thin wall socket fit.....
Posted by: 76-914 Jun 16 2018, 07:21 PM
QUOTE(Tdskip @ Jun 16 2018, 05:27 PM)
One I have is too thick...
Jesus God, that's a Fat Crows Foot! And the Mlinder is correct. A thin wall socket or line wrench will also work. They shouldn't be very tight.
Posted by: Tdskip Jun 17 2018, 05:38 AM
Thanks guys. No more donuts for that crowfoot set.