So I bought my MIG Yesterday.
Ready to start fixing my door sill. What do I have to do to protect my Mallory 6A ignition?
disconnect battery leads. Do I need to remove the CD box?
Lost my paperwork for the unit.
couldn't hurt.
i would at least disconnect all but the negative.
actually, i'd disconnect that too.
(my opinions on what you should *really* do with an MSD-6 are already on record, so i won't go there again...)
found it.
http://www.centuryperformance.com/mallory/techfiles/MA1522_Hyfire6A_6AL.pdf
Says to disconnect tach ground as well as all power leads to the box
Yea Rich good thing I have a Mallory
joe,
i just looked at the manual....
welding: unhook the mallory hyfire when you are welding on your ride.....
id just do both poles
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)