Printable Version of Topic

Posted by: Lucky9146 Jul 12 2018, 06:07 PM

I am looking for "Press In" Bullet Nose Wheel Studs. Any Help Appreciated. They may not exist!

I like the look of Bullet Nose Wheel Studs and have seen them as pictured below on a 914-6 GT conversion and on other 911's.

I noticed they were used on Fronts as shown here, but don't know why only front?.





I have ONLY found these "THREAD IN" Type at Rennline and I want "PRESS IN" if they exist at all.


So far I have Looked at:
Stoddard
Rennline
AA
PMS
Aase Sales
EBS Racing
Ebay
Sierra Madre

Thanks for looking

Posted by: mepstein Jul 12 2018, 06:21 PM

They do exist. They are very cool. Did you call Eric @ PMB. There are also some race shops that sell them but I don't have names offhand.

Posted by: sixnotfour Jul 12 2018, 06:22 PM

Apex

https://www.apexraceparts.com/accessories/stud-kits/arp-m14x1-5mm-s550-stud-kit.html

or buy verbus 100mm and have the bull nose machined on them..

Posted by: pete000 Jul 12 2018, 06:23 PM

Elephant racing has all the studs you could ever want.

Posted by: live free & drive Jul 12 2018, 06:23 PM

Sway-A-Way and Elephant Racing amongst others.
Sway-A-Way are quite quite a bit less expensive...

Posted by: sixnotfour Jul 12 2018, 06:37 PM

https://swayaway.com/product/wheel-stud-14mm-x-1-5-thread-bullet-nose/

the swayaway studs didnt use to threaded far enough down needed small spacer....ok 20 yrs ago

Posted by: Lucky9146 Jul 12 2018, 06:42 PM

QUOTE(mepstein @ Jul 12 2018, 05:21 PM)

Posted by: Lucky9146 Jul 12 2018, 06:45 PM

QUOTE(sixnotfour @ Jul 12 2018, 05:37 PM)