I know this has been covered (and not too long ago) but can't find it.
I'm looking for the proper way to wire a front mounted fuel pump in an original six.
I'd rather not run wires from the original rear harness forward.
As I recall Dave Darling suggested a proper arrangement.
Anyone ?
All you need is a switched hot wire and a ground. Find a vacant switched slot on on back of fuse block or install a piggyback plug to a used hot switched wire on the block.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)