Anyone have a set of pipes that would bolt on to a type IV heat exchanger with exhaust flanges that are trapizoidal in shape and dual pipes in each flange?
They need to be as low profile as possible....
The HE interface looks like this.
Attached image(s)
i could wack these off and send them to you.
Attached image(s)
C O O L.....what do you want for them......?
free is cool, just pm the address to the p-car garage.
the whole thing or what length on the pipes? i would love to cut her open.
cruched, but minimal rust.
Attached image(s)
Cut and ship it....
that's why i love this place. the world would be so much better if everyone was so helpful, all the time.
kevin
the debauchery begins at high noon.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)