Hi all,
I took 3 pictures from the center tunnel and dropping from the dash. The 4 little wires I think should have gone into a plastic housing which would plug into one of the gauges in the appearance group housing. There is also a little brown wire that is part of the harness and is short and a bigger red one that is laid on top of the harness (aftermarket)? Your input is much appreciated as I am getting close to getting this project on the road.
Thanks much,
Gary
Another picture added as file size was to big to put in that one post
And last but not least one more picture for clarity.
The little black hoop connection to the left next to the bulb, where the heck would that go? I do not see any place on the 3gauges that would accept the connection.
Thanks again,
Gary
Aftermarket. Oil pressure maybe. You will have to track it down in the rear.
Center console gauge wiring - think about defrost light on the center console.
The long branch of the 4 wires from the dash may be for the pass side door switch if you have an early model year car.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)