We now have factory look gauges to fit in the center console. These are the exact original factory size and are complete with the rubber gasket. 35.00 each
volt meter, oil temperature, and oil pressure
Nice! Now I'm torn... I have a smaller set on order so I can make room for a pyrometer and boost gauge...existing temp and volts working with my diesel. Oil pressure replacing the clock would be cool if I didn't want room for more.
Do you have the rubber gasket available separately?
Thanks
Chris
yes Chris.
We also have the smaller oil pressure gauge available for tight applications such as in the dash face for some of you racers
I ordered, oops, I had to have my girlfriend order, a "NOS" fuel/brake light gauge from you. It arrived and was a POS. Dirty, scratched bezel, remember, you took her call. (you hung up on me) You sent a replacement eventually, but I swear I will NEVER buy anything from you as long as I live.
(Rant over.)
Wait, the reason you hung up on me is, because I had a prior BAD transaction with you; you sent a different part before that you wouldn't replace and I had to finally resort to negative feedback on eBay.
Buyer beware.
YMMV.
Can we all put a headline in the Garage section every time we list a part in the
Classified ?
Finely! I tried to order one from Northhollywood and it was going to cost TOO MUCH. My order will go in this weekend. These are the 60mm size?
yes the 60 mm sized gauges. Brutus the 916 has one installed on the aux console
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)