I've been installing the shift rod on my 914 restoration.
So I managed to get the rear rod connected where it connects to the transmission mechanism. However, when i went to connect the rear rod to the front rod just inside the engine compartment, (The connection in the example photo below) I noticed that the hole that the screw goes into is on the TOPt side of the rod, and not the BOTTOM where the screw from the rear rod would attach. It looks like the rod from the front shifter is upside down. Ugh
Is there anyway to deal with this except to open up all the front shift area and turn the rod ? unfortunately all the carpet and center unit has been installed already. I assume drilling a hole in the rod isn't smart?
The cone screw is supposed to index into the indent on the rod.
Do it right.
Google pictures and/or videos on Youtube.
The hole is indexed so that it lines up with the rear connection,if the rod was straight it wouldn't matter but its far from that.
Not something to get wrong. The rod is only to go one way, and the holes for the cone screws will dictate the proper orientation.
Also, make sure all your bushings are fresh and tight, it will make the car shift as good as possible. I just had the rod apart yesterday to install a delrin bushing I made for the console, made a huge difference.
Chris’s firewall bushing is beyond anything else available, well worth the money.
I guess I knew the answer here and was hoping....but thanks..I'll go and open up the inside...
It sounds like the bushings were replaced on the knuckle and it was installed upside down during reassembly.
I re-read the original post and it actually sounds like the tunnel rod is installed upside down.
The picture provided really does no good since it isn't a 914 shift linkage.
The hole in the tunnel rod should be on the bottom, as the threaded hole in the knuckle should be.
Final adjustment of the shift linkage needs to be done in the tunnel, at the rear of the shift lever anyway, so it is expected that opening up that area is necessary.
Chris - you stated in correctly...so I will open up the inside and then loosen the seat and rotate. Thanks all.
When working on a restoration keep in mind that every section completed must be taken apart at least one more time. Put it together with the intent to take it apart again.
The oval piece the boot goes on is missing? the forward end of the rear shift rod for a side shift trans looks like this. The hole for the set screw in yours is 90* wrong. Not the same part.
Attached thumbnail(s)
I'm dealing with all of this, this week, so I'll be watching. Mine is orientated correctly but still about to give up.....
Is this related to work on your 74'?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)