I am going to replace my clutch with the superkit from PP while doing my top end rebuild in the next few weeks.
Is it pretty much a no brainer to have the flywheel re-surfaced? The clutch is working fine but the throw out bearing is starting to whine a bit, so i figure I might as well replace it all while i'm in there.
Thanks
Luke D
If it has enough for another cut. Many flywheels are already too thin. Get it resurfaced. As my machine shop would say, "Unless you like dropping your engine."
it's not that expensive(mine was abbout $40) and you'll probably see, when you get it off, that it needs it...
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)