I'm looking for a source or a suitable substitute for the grommets for the fog light and horn wires exiting the body then the smaller grommet for the wires entering the fog light housing.
What have others done?
The cone shaped one is part # 311.971.909 and I got mine from Wolfsburg West http://www.wolfsburgwest.com/cart/DetailsList.cfm?ID=311971909
I haven't been able to track down that small one yet despite a lot of searching.
https://www.ebay.co.uk/itm/Blanking-Grommets-Rubber-Closed-Grommet-Blind-Hole-6mm-9mm-12mm-16mm-20mm-/271140812144?redirect=mobile
Bought several sizes of these at the now defunct Orchard Supply Hardware. I would try Lowes or Home Depot. These are 3/8" and fit perfectly for the fog lights.
I know of some in the Phillipines.
Delete
We've made the correct size ones just waiting for Blake and Matt to get up on the new site. I'm still in training, but I know we have them as I made them.
These are actually made with a seal inside to allow wires to go through and help keep water out, not an ordinary grommet.
Attached thumbnail(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)