Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Window Scraper Install Question
Posted by: Highland Nov 27 2018, 11:51 AM
I'm putting my door back together and have everything in including the fuzzies on both sides. The window goes up and down smoothly until I install the scraper. Going up I can here the rubber scraping against the window and going down it can bind bad enough the friction from the window starts to fold the scraper over.
I removed the from trim guide to give the glass more freedom and tried supporting the glass manually and the rubber scraper still binds.
Advice please.?
Posted by: 76-914 Nov 27 2018, 02:02 PM
!) Did you remove the alum bar that holds the rubber piece. If so did you re-install it using the same screws holes? If it was installed a bit low it will do as you are describing.
2) Can you see a small hump running lengthwise down the middle of the rubber strip. If so it isn't seated properly.
3) Does the window glass mate properly with the top and back side?
4) Does it free up if the interior door card is removed?
5) Is the rubber strip oriented correctly. It can installed backwards. 
Posted by: dr914@autoatlanta.com Nov 27 2018, 02:14 PM
wax your window
I'm putting my door back together and have everything in including the fuzzies on both sides. The window goes up and down smoothly until I install the scraper. Going up I can here the rubber scraping against the window and going down it can bind bad enough the friction from the window starts to fold the scraper over.
I removed the from trim guide to give the glass more freedom and tried supporting the glass manually and the rubber scraper still binds.
Advice please.?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)