First, thanks to 914 Rubber for getting the Black Friday orders out so fast. I was not expecting parts for some time.
Is this what the vertical targa seal should look like with the window all the way up?
I want to verify before I cut the excess off the bottom.
Also, for any of you who have installed 914 Rubber's triangle window seal, do we have to cut our own slot (on the bottom) for the metal mount tab?
The upper pointy tip of the aluminum holder and the tip of the seal should
match.
Put the roof on and start adjustin'
Ideally the 45 degree ends of the two seals should be virtually touching.
Is your window fully up ?
Tinted glass.....mmmmmm.
Yes, my window is fully up. Do I need to adjust it to go higher?
Does anyone have a picture of an ideal setup?
Oh, the car is a 73, so I think everything is late.
Rubber tends to shrink with age, so I usually squish it in. Also might still be stretched from a tight fit during install. But it might have been cut long, some other 914rubber seals are cut to fit.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)