Posted by: buck toenges Dec 11 2018, 01:16 PM
The plastic connector for a fuel injection connector broke off. I have a new one to replace but which wire goes to the correct side of the connector? What do you have to do to make sure it is wired correctly? What is the best way to connect the wires to the harness?
Thanks,
Buck
Posted by: dr914@autoatlanta.com Dec 11 2018, 01:35 PM
splice on a new connector by soldering and heat shrinking, easiest way. We have all of the plugs and boots if you cannot find them, also we have the female ends and hollow connectors if you want to get more sophisticated
QUOTE(buck toenges @ Dec 11 2018, 12:16 PM)
The plastic connector for a fuel injection connector broke off. I have a new one to replace but which wire goes to the correct side of the connector? What do you have to do to make sure it is wired correctly? What is the best way to connect the wires to the harness?
Thanks,
Buck
Posted by: rjames Dec 11 2018, 02:14 PM
QUOTE(buck toenges @ Dec 11 2018, 11:16 AM)
I have a new one to replace but which wire goes to the correct side of the connector? [b]What do you have to do to make sure it is wired correctly?
I was told that it doesn't matter. The injector will work either way.
Posted by: Mblizzard Dec 11 2018, 02:15 PM
QUOTE(rjames @ Dec 11 2018, 12:14 PM)
QUOTE(buck toenges @ Dec 11 2018, 11:16 AM)
I have a new one to replace but which wire goes to the correct side of the connector? [b]What do you have to do to make sure it is wired correctly?
I was told that it doesn't matter. The injector will work either way.
Yep that is correct!