I'm curious to see the different style openings for radiator inlets on the V8 Teeners....I'll be starting the surgery soon on JLO....
Let's see them holes!
Bill p.
Here's mine Bill
Attached image(s)
Mine probably doesnt count since it is not a stock front end but here is mine.
Attached image(s)
Thanks!
I'd like to come up with an opening that looks nice and clean....and maybe with a grill that is not only mesh, but has a shape...something that Guy T. has. But I can't blindly rip that off....
I do have an extra grill for my Ford F150 pickup...but it doesn't look that nice...
Bill P.
Bill, I have some different things I have been considering to use for a grill to keep low flying birds and such out of my radiator opening, I will take some pictures of two different kinds tomorrow. I have a lot of both so if you decide one of them might be right for you, let me know and it's yours.
Thanks Scott!
That would be awesome....With JLO we can be a little different...
Bill P.
Yep...I had even money on Karl coming up with the posting to match my topic title!
And his opening is the same color as JLO!....
Bill P.
Bill, I found that material I had so here are the pictures. The first one is a shiny silver coler like expanded steel but its light like aluminum. Not sure what it is made out of but should work great for a grill. The other one is heavier and black but is also metal. Much finer mesh than the silver one.
Attached thumbnail(s)
scott...
ill buy some (like 4 x 13") of numba 2 off you
Bill,
Can I have the piece you cut out? I may have a use for it on Neo914...
This is from Richard Fishers car.... Notice the flames.....
Attached image(s)
You need to be careful with a thread title like this one.....
After all.. MikeZ hangs out here!
This is what I did to mine after spending much time worrying about how my freshly chromed front bumper would look after hacking it up. This method was fairly simple to perform and did not take much away from the stock appearance. The wire mesh was purchased at Lowe's and riveted to the body. Just cut mesh about 3/4" larger than hole in body........the hole in bumper will be much smaller and cover any imperfections.
It may not be so obvious with the bumper on a table or with the car on jack stands, but with the low ride height of the 914 and the angle of the stock bumper, this opening is barely visible to the average person. You just about have to get on your knees to notice any detail
Attached image(s)
close up
Attached image(s)
normal view
Attached image(s)
If you're looking for a nice grill...
Get one off an SC or Carrera 3.2 taildragger engine lid (one without a rear spoiler)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)