When holding the flap on the DS door to try and get it to stay locked, the door just bounces back. With the panel off the latch on the back/end of the door is nice and clean, and I lubricated it, but didn't seem to help any, or am I addressing the wrong problem?
I can get it to lock with the key from the outside, but I thought when using the lock button from the inside, and closing the door from the outside, as long as you hold the flap, it was to lock that way also?
One other thing, with the door open, if I use the key turn right, and watch the tab by the interior door handle, it pulls it in further, and so when I remove the key, and hold the flap, it will lock, but if I just push that tab by the interior door handle, it won't lock that way, and it appears that just pushing the tab, it is not pushing it far enough to lock.
Close door, turn key
I have always considered the door locks to be a week point on these cars. At least every year or two I will take both door locking mechanisms out, clean them thoroughly with carb. cleaner. Repair and replace as needed. Make sure everything is lubed well and then re-install. The doors locks work effortlessly. Well, mostly.
Is the key correct for the handle? Can you lock the door with the key?
Don't know if this may be your problem but if too long a screw is used on the plastic cover around the inside locking tab it hits. try removing the screw holding the plastic cover and see if that cures your problem. then either grind down the screw or fit a shorted one.
I finally just took out the gizmo on the end of the door. Was a bit sticky, but I think the other part of the problem is that I am missing one of those rubber guides for linkage, and had a bit of bend in it, and so I took some of the bend out, and till I can get another guide, I just pulled the linkage in a bit with some wire. Anyway, it works as it should now.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)