Hi everyone, I’m now trying to reroute my rear wire harness and was thinking it would be obvious to route the driver side one that goes back to the taillights. But I’m kinda confused how It routes through the engine compartment on the side of the car before it goes out into the trunk. Any help would be much appreciated thanks
I just did this in my car AND my name is Shane too. The coincidences don’t stop. This photo shows the new tubing over the wire holders, new snorkel, alterator wire harness and ground wire because I’m running carbs. All from 914rubber. It’s a 1975 car. Don’t let the beauty overwhelm you.
Attached thumbnail(s)
Thanks for the pics, looks great especially the color!!! The coincidences keep on going here’s a pic of my project. It came with the little carb will be going back to FI after I get the car all put back together. Just want to drive it before the end of summer if possible. Thanks again
This is weird
...........too late (the beauty DID blow me away)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)