Printable Version of Topic

Posted by: cal914 Apr 23 2019, 03:07 PM

I’ve got a short shifter with tangerine sport linkage ,after taking the engine out and putting back in I can’t get first or reverse but all the other gears
What do I have to adjust to sort this out

Posted by: Superhawk996 Apr 23 2019, 03:30 PM

Assuming you didn't disturb the linkage from firewall up to shift lever and that you had a working shifter before the engine and trans came out.

I'm also going to assume you have a late model side shift transmission. If you have a tail shift disregard all my info below and post the year of your vehicle so we can be sure of what you have.

Sounds like you are getting full in/out motion of the shift lever that comes out of the transmission. By "in/out" I mean into and out of the transmission itself.

Try shifting the trans end linkage by hand. If you can engage all gears then you can be sure the issue is with the linkage itself. Sometimes you can get a blocked gear(s) with the vehicle static. Try rolling it (or turning both wheels simultaneously if jacked up) to ensure that you don't just have gear clash preventing static shifting.

Check the attachments both at front and rear end of the shift linkage that is routed beneath the engine.

Both ends have a conical fastener (OE is a hex head screw with a conical tip) to index the respective ends to the other linkages. if those conical fasteners are not indexed properly you will have issues.

Posted by: ChrisFoley Apr 23 2019, 03:58 PM

QUOTE(Superhawk996 @ Apr 23 2019, 04:30 PM)

Posted by: SirAndy Apr 23 2019, 05:16 PM

Make sure all the shift linkage couplers are tight (double check them cone screws), then losen the shift rod at the base of the shifter.

Put the transmission into 2nd by hand, put your shifter forward and center and tighten the shift rod.

That way you should have the 2nd/3rd plane in the center of the shifter and be able to go left/right for 1st/rev and 4th/5th.

Posted by: VaccaRabite Apr 25 2019, 11:46 AM

I have the full boat upgrade on my car too, and getting it adjusted took some time.
While tuning the shifter, make sure the up and down shift stops are backed off. You close those down last.

When I did it on my car, the shift rod itself was just barely touching something (I don't recall what) on the 4/5 plane that made those gears a bitch to get to. I had to relieve the impingement and suddenly everything went much easier.

As Andy said, you gotta start with the 2/3 plane.

Find one of DrEvil's posts and download the Shift Adjustment document that he has linked in his sig file. Its comprehensive and will get you there.

Zach

Posted by: Mikey914 Apr 25 2019, 01:12 PM

It’s the lateral throw that’s not far enough. You loose these gears when the stock knuckle bushings fail. It doesn’t “twist” enough.

Posted by: mepstein Apr 25 2019, 02:56 PM

QUOTE(VaccaRabite @ Apr 25 2019, 01:46 PM)

Posted by: mepstein Apr 25 2019, 02:59 PM

QUOTE(Mikey914 @ Apr 25 2019, 03:12 PM)