Putting car back together after rebuild. Ran before I took it apart. Ran through the checklists I’ve found online so relay board is good. Pump works when I put yellow wire from 12 pin connector on terminal III so wiring to pump is good. What I don’t get is the 1.5 second run time when I turn the key or have pump running when I crank motor. No 1.5 on terminal 87 when I turn key on either. Check list says bad relay but I replaced with one from headlights that I know works. Stuck.
I used this checklist.
http://bowlsby.net/914/Classic/zTN_FI_FPChecklist2.pdf
Attached thumbnail(s)
Pump won’t turn on unless the air intake flapper (not sure that is what it is called) in the AFM opens with the intake of air when cranking. It may be stuck from sitting. Take the air filter off and prop open that flapper then give it a crank. This is specific to l-jet. Had the same issue with my 75 1.8l.
If the car is original ,you have a l-jetronic not a D-jetronic.Use a checklist for the l-jetronic.I would check first the dual relay, it is under the Battery if I remember me correct.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)