Does anyone have rough dimensions for the through hood GT filler hole??
http://www.914world.com/bbs2/lofiversion/index.php?t235488.html
Attached image(s)
Perfect.. This is directly inline with the center of the standard gas tank fill hole?? Just want to make sure.
I think the sharpie taped to the center of the gas cap would give you a perfect measurement, maybe cut the sharpie in Half or less so it just hits the hood. Drill a pilot hole and good to go. all tanks sit a little different. Just 1/8 off would make a huge difference in alignment.
I hope that 1/8" wouldn't be noticeable .
I put (temporary glued) a short drywall screw exactly in the middle of my gas cap and carefully shut the hood down on it to get a rough idea. It worked like a charm.
That's my drawing, but every car is a bit different.
Check those measurements against your filler.
I put a short piece of soft chalk on the center of the gas cap, then gently lowered the hood to make the centering mark.
Just measured mine based off what is drawn.. It's pretty close but it sticks 1/2" in one direction.. I will need to mount the hood and verify.
So how big does the hole need to be to clear a correct (100mm) "fancy" GT cap?
Ben, please post pictures of your process and results. Thanks, Mark
Old post, thanks Ben for sharing. Car looks great. Mark
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)