I'g putting the engine tins back on getting ready to put the engine back in the car. I have this gasket that I don't know where it goes or what it is. Any ideas?
https://ibb.co/h8bWJLT
https://ibb.co/whNvL7P
Hard to see scale from the photos. Looks like seal between engine tin and oil cooler to me.
This one.
I have new ones 10.88 that fit better than OEM in silicone. definitely a needed part
https://900designs-container.zoeysite.com/oil-cooler-and-tin-gasket-1
Attached thumbnail(s)
Attached image(s)
Awesome. Thanks for all the help everyone
. I'll pull the tins back off to install that.
All your seals like this one are important as the T4 runs somewhat hot anyway,every bit makes a difference,clean crankcase,cooler,and good engine bay seals and correct working thermostat go a long way to making it a motor that will do large miles after a correct rebuild.
Good luck.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)