Can someone post a pic of the proper way to route the FI wiring harness? Over/under what components?
Got my new one hooked up from Mr. Bowlsby but it seems like the distributor hook up is pulling a little so I'm guessing I've routed the wires the wrong way.
Thx all!
Side note...I HATE THE FUEL HOSES UNDER THE TANK, WHAT A PAIN IN THE ASSSSSS!!!!!
I took pictures of routing on my 2.0l
Not up on my thread but I’ll post to this one late today unless someone can get up sooner
Hmm. Not exactly crystal clear but hopefully it helps. My engine is 2.0L so not sure about applicability to other variants.
main harness routes in along passenger side. Goes to rear tin.
Distributor take out spits out to rear of the tin on the passenger side of the air plenum. routes under the plenum runners.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)