Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Engine cross member
Posted by: Sycolyst Aug 3 2019, 05:38 AM
Hello all,
First post on the forum after lurking for a while. I am restoring a 73 914 and discovered that the engine cross member sits at an angle towards the back as if the previous owner ran over something and pushed it to the rear. My question...does this cross member naturally have an angle or is it supposed to be straight. I am pulling the engine now and plan to drop the cross member once removed. Any help would be appreciated.
Posted by: ClayPerrine Aug 3 2019, 05:46 AM
It should be straight. Someone hit it when driving. You will need new brackets that mount the crossmember to the chassis. The bolt in.
Posted by: IronHillRestorations Aug 3 2019, 05:48 AM
Very common to see this, the brackets and/or bar is bent
Posted by: Sycolyst Aug 3 2019, 05:58 AM
Appreciate the quick response, it is what I thought. This site is going to be a wealth of information as I proceed. Hope you don't mind the questions to come. Thanks again!!
Posted by: mepstein Aug 3 2019, 07:48 AM
Like Clay said, new brackets. The crossmember can be bent back.
Posted by: Maltese Falcon Aug 3 2019, 08:13 AM
Posted by: bdstone914 Aug 3 2019, 09:43 AM
@http://www.914world.com/bbs2/index.php?showuser=23312
You want to replace the two rubber mounts between the bar and brackets at the center. The bolts are probably bent too and may need to be cut .
I sell sets of improved end brackets and hardware for $35 shipped.
I will post the link to that thread later
Posted by: dr914@autoatlanta.com Aug 3 2019, 09:54 AM
although we have new outboard solid mounts (the ones that are bent causing the crossmember to lean) you can remove yours, put them on an anvil and beat straight with a hammer and reinstall. Easy and will make the bar mount straight again
Posted by: bbrock Aug 3 2019, 10:18 AM
although we have new outboard solid mounts (the ones that are bent causing the crossmember to lean) you can remove yours, put them on an anvil and beat straight with a hammer and reinstall. Easy and will make the bar mount straight again
+1 That's what I did before sending them for plating.
Posted by: SirAndy Aug 3 2019, 10:19 AM
http://www.914world.com/specs/tech_engdrop1.php
Posted by: Sycolyst Aug 3 2019, 07:47 PM
Thank you. Appreciate the link!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)