Printable Version of Topic

Posted by: germaneighter Oct 16 2019, 03:18 PM

It's not been on the road for 6-7 years except for a week back in early 2016 while doing a clutch replacement on my Boxster. It wasn't running great during that week but it got me to work and back. I suspected the injectors were gunked-up.
I've been saving this car for retirement - restoration project but I'm still a few years out and my energy level coupled with joint pain got me thinking maybe I should just get it running and enjoy driving it while I still can.

My basic plan is:
Drain fuel system
clean injectors
replace fuel & vacuum lines
New plugs and wires
adjust valves
new battery

The ignition is a crane unit - can't remember the specifics. Tires were near new when I first stopped driving it but probably flat spots now.

Any additional suggestions to get it back on the road?

Posted by: Mikey914 Oct 16 2019, 03:21 PM

DO IT

Posted by: aharder Oct 16 2019, 04:26 PM

QUOTE(Mikey914 @ Oct 16 2019, 04:21 PM)

Posted by: Mikey914 Oct 16 2019, 07:29 PM

Drain the fuel
add a few new gallons
New battery - or charge
disconnect the ignition coil wire and crank over for about a minute
I'd bet it fires right up once you connect the coil back up

check the brakes and drive it down to get the new plugs and wires and what you need.

Posted by: VaccaRabite Oct 17 2019, 07:57 AM

Do it now while you have the energy. Make it so you can drive the car during retirement and enjoy it.

If you like building cars, you can always build another car. Doing your 914 now will only increase your skills down the road.

Zach

Posted by: sb914 Oct 17 2019, 08:33 AM

Great color!

Posted by: dr914@autoatlanta.com Oct 17 2019, 09:00 AM

I would put some marvel mystery oil in the cylinders overnight then turn the car over the next day (with the spark plugs out) then remove the fuel pump relay and air cleaner, make sure the car has a spark and try to fire it up on some spray gas (fire extinguisher on hand!!!!!!!!) keep spraying the gas until the engine runs smoothly. THEN change the oil, clean the strainer basket, drain the gas, look in the tank for cleanliness, put a new fuel filter on and make sure that the fuel pump cycles (if not and it has the initial electric pulse, tap it with a light hammer) then check the fuel pressure and try to fire it up before you take the car apart and do too many things to complicate the process. After you get the car running then try to drive it before doing anything else (assuming the transmission is full) and see what else needs to be done besides a THOROUGH service

QUOTE(german eighter @ Oct 16 2019, 02:18 PM)

Posted by: PanelBilly Oct 17 2019, 10:47 AM

I’d use a leaf blower to clean out around the engine too.

Posted by: Mikey914 Oct 17 2019, 11:00 AM

Also, I'm hoping your gas is pre ethanol. If not your fuel lines are suspect. It eats the rubber. I think you may be ok, but I only run clear gas now for that very reason.

Posted by: ctc911ctc Oct 17 2019, 12:16 PM

Having done this to a '74 2.0 during this past year I would strongly advise replacing the fuel lines. My guess, if they are original, is they are as hard as rocks and as brittle as glass.

I replaced mine with Tangerine stainless lines and a complete hose set from Auto Atlanta........ worth the peace of mind.......

I will bet that all burned down 914's were the product of these lines failing.

My 2 cents.

CTC911CTC

QUOTE(germaneighter @ Oct 16 2019, 03:18 PM)

Posted by: ctc911ctc Oct 17 2019, 12:17 PM

QUOTE(dr914@autoatlanta.com @ Oct 17 2019, 09:00 AM)

I would put some marvel mystery oil in the cylinders overnight then turn the car over the next day (with the spark plugs out) then remove the fuel pump relay and air cleaner, make sure the car has a spark and try to fire it up on some spray gas (fire extinguisher on hand!!!!!!!!) keep spraying the gas until the engine runs smoothly. THEN change the oil, clean the strainer basket, drain the gas, look in the tank for cleanliness, put a new fuel filter on and make sure that the fuel pump cycles (if not and it has the initial electric pulse, tap it with a light hammer) then check the fuel pressure and try to fire it up before you take the car apart and do too many things to complicate the process. After you get the car running then try to drive it before doing anything else (assuming the transmission is full) and see what else needs to be done besides a THOROUGH service

QUOTE(german eighter @ Oct 16 2019, 02:18 PM)

It's not been on the road for 6-7 years except for a week back in early 2016 while doing a clutch replacement on my Boxster. It wasn't running great during that week but it got me to work and back. I suspected the injectors were gunked-up.
I've been saving this car for retirement - restoration project but I'm still a few years out and my energy level coupled with joint pain got me thinking maybe I should just get it running and enjoy driving it while I still can.

My basic plan is:
Drain fuel system
clean injectors
replace fuel & vacuum lines
New plugs and wires
adjust valves
new battery

The ignition is a crane unit - can't remember the specifics. Tires were near new when I first stopped driving it but probably flat spots now.

Any additional suggestions to get it back on the road?

Posted by: dr914@autoatlanta.com Oct 17 2019, 01:09 PM

getting it running and test driven with the most minimal work you can do is paramount, THEN write your list, as you will know everything wrong with the car by then. That is what we do here with any 914 that comes to our shop not running

Posted by: johnhora Oct 17 2019, 02:31 PM

One last thing to check are BRAKES

All of these excellent recommendations will get it running but you have to Stop it too on that exciting first test run.

Good luck with the reawakening...

Posted by: germaneighter Oct 17 2019, 03:48 PM

Thanks for all the feedback! Very helpful.

Posted by: porschetub Oct 18 2019, 12:17 AM

I would carefully check the fuel lines from pump around the system and back to the fuel return,bet the hoses will be suspect,make sure the short hoses on your injectors are ok also.
Replace this hose with the best rated hose you can buy and check/replace FI hose clamps as required.
Run a low clean fuel tank with maybe 5 litres and a full bottle of injector cleaner,had good luck in the pass with this method.
Don't forget to check rubber flexible brake lines as they fail by age and not use...ask me how I know,my car was in dry storage from late 90's on till I bought it in late 2014 all new (?) lines were all perished,be safe ok.

Posted by: Tdskip Oct 18 2019, 07:09 AM

QUOTE(johnhora @ Oct 17 2019, 03:31 PM)