Ok, I know that I am not telling anything new here, but the quality of Ben's work is just too good to not say it again. The welds on this stainless 914-6 sport/race muffler are so beautiful, I had to share. With a little wet sanding and polishing, I have a conversation piece for the coffee table, instead of something to hide under the car
Thanks again Ben for your fantastic work!
@http://www.914world.com/bbs2/index.php?showuser=9892
Beautiful work.
Look at the quality thickness of the exhaust flanges and the reinforced exhaust tips. Both are failure points on most mufflers.
Thanks Danny.. Best news is that I can now offer these even a bit cheaper in the future.
Looks awesome. My muffler wasn’t cheap to fab, but sounds great. $200 for the muffler $300 to fabricate
These mufflers I can sell for $400 plus shipping so excited about that. I have out sourced just this model to a local 2 man shop and they want the work.. I can't do it all so benefits everyone..
Beautiful work, Ben!
I’d love to hear the sound. I’m happy with my stock 914-6 muffler, but 12#!
Now I’m intrigued...
I shot some short video of it at idle. If I can figure out how to post it, I will.
I would love to collect some audio samples as it winds up through the gears
Sounds nice and screams...
I like it. Is that for a /6 or a 4-cyl? Might look good on my track car.
That welding is unreal ,way better than when I could do before becoming half blind ,top job Ben.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)