039919268. factory 200 degree sending unit for the 914 factory temp gauge, and will fit 911 as well. We are gathering parts for a 914 console package that resembles in look size and dimension the original factory unit. This is one of the parts that will be included
Long time needed part. 200 degree was hard to find. I see it even has a nylon washer.
The other part that is needed is the rubber grommet for the cover guiding the sender wire
AA and 914Rubber both have the rubber boot
^^^ As does bughaus and bus depot.
Are you selling these individually? I don’t see it listed on your site.
I have every piece of the console set up except this.
i have the stock sending unit that came with my car when I bought it.
where are these typically installed? on the drain plug?
I bought mine from my local porsche centre. It was listed under the 911 not the 914. Not that much either.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)