Putting on finishing touches and ran into this:
Research shows that there is only ONE version of this Molding - the car is a 74 2L.
Why are the holes not lining up?
What am I missing in this picture?????
I've seen at least two different sizes ...
Did you raise the bridge or lower the river?
Seriously, are there replacement lights that are wider?
Hard to tell if mine are wider or not...
should certainly fit, the screw holes are in different places but that is easily overcome
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)