Long story short I was taking off the cooling system and while reinstalling the fan impeller I noticed I do not have the spacing washer. Anyone know the thickness of this washer? Duh.. moment.
When reinstalling without the spacer, I over tightened the screws and damage the crankshaft seal (see pic)
Anyone have a part sitting around to donate to the cause to help RolinkHaus.
@http://www.914world.com/bbs2/index.php?showuser=22330 - post over in WTB also if one of these fine folks don't have a spare sitting around
@http://www.914world.com/bbs2/index.php?showuser=18761
@http://www.914world.com/bbs2/index.php?showuser=1319
@http://www.914world.com/bbs2/index.php?showuser=865
#3 in PET diagram
I found one.
.077" or 1.94mm thick.
You can have it for cost if shipping.
Will PM my email for PayPal.
Bruce
Make sure you are using the correct bolts ad a longer lenght will cause that same problem.
@http://www.914world.com/bbs2/index.php?showuser=22330 ' date='Apr 1 2020, 07:31 AM' post='2799810']
Long story short I was taking off the cooling system and while reinstalling the fan impeller I noticed I do not have the spacing washer. Anyone know the thickness of this washer? Duh.. moment.
When reinstalling without the spacer, I over tightened the screws and damage the crankshaft seal (see pic)
[/quote]
Thanks guys for the help that’s awesome.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)