I have the necks & caps but need to make some flanges and gaskets.
Do any of you know Hole Dia & Bolt Circle dims?
TIA
Oscar
Oscar,
I will measure mine in a few minutes, or I can bring over my filler neck to make a template if you would like.
Bob
Oscar,
There are 8 evenly spaced holes (45 degrees apart)
Bolt circle measures 3.224" dia.
Bolt hole diameters measure 0.234" (with paint on the ID of the holes of my filler neck).
The opening of the tank measures 2.808".
The gasket surface OD measures 3.910"
I measured twice, if you want me to bring the tank and filler neck over to transfer the pattern let me know.
Bob
@http://www.914world.com/bbs2/index.php?showuser=16669
' date='Jun 8 2020, 03:04 PM' post='2823320']
[quote name='bob164' post='2823319' date='Jun 8 2020, 03:02 PM']
Oscar,
I will measure mine in a few minutes, or I can bring over my filler neck to make a template if you would like.
Bob
[/quote]
Please Bob...I have a spare tank in storage but it's 8-10 boxes deep and behind extra trans.
Let me know...thx
Oscar
[/quote]
I measure 82 mm bolt circle and 70 mm hole size. Measured off of a tank.
THANK YOU....I think this info will work.
I had about 10 flanges laser cut and can't remember where they are.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)